First transmission through a real radio path in the project. A 4756-byte
JPEG went from transmitter to receiver over two antennas 60 cm apart at
225 MHz and reassembled byte-identical, reproduced across three runs.
The cable loopback still needs an SMA male-to-male adapter that has not
arrived, so this air run is a track verification, not the controlled
measurement: room levels are not held the way a cable holds them. Its
purpose was to exercise the device wrapper the models cannot cover.
Four defects the software model passed but the hardware exposed, each
reproduced and fixed:
- a 566 528-sample frame did not fit the 262 144 receive buffer, and the
sample stream is not continuous across separate reads, so a frame on the
seam was destroyed. Reception now uses one buffer sized to the frame
- carrier correction was always applied, but with a shared reference the
true offset is near zero and the 80-symbol marker estimate is noise;
correcting by it rotated phase along the whole frame, 65% bit errors
measured. Ported should_apply_cfo_correction from Lab023
- receiver gain of 20 dB left the signal at 0.0003 of full scale. Levels
set by measurement: RX 50 dB, TX -10 dB give zero bit errors with margin
- the error-vector metric returned zero on a failed receive, reporting a
perfect signal where there was none, the same class of defect as the
written-in figures of Lab041. Replaced with an explicit not-computed value
The air TX gain ceiling is now derived from the link budget by antenna
distance rather than a constant. Three loopback modes: software, cable,
air. PROJECT_LOG entry 019 records the run and the defects.
Software and cable results stay reproducible; 125 tests pass, gate passes.
